iTecs Srl

It is easily to install on a motive or on a trailer, and it’s equipped with:

• A 12 channels GPS receiver and a GPRS multi slot class 10 modem, that allow to send the position of the vehicle at prearranged intervals from a minimum lower than a minute, to a maximum of 24 hours.
• 1MB Flash memory and 64KB RAM allow to save positions or obtain informations from installed sensors, and send them on user’s request.
• Moving and temperature sensors.
• 4 digital input, 2 analogue input, 3 digital output, for equip the vehicle with apposite sensors and command by remote some circuits as the centralized lock or the engine’s block-system.
• RS232 o RS485 interface for the connection to a supplied organizer computer used by vehicle driver otherwise for the connection with a printer for the print of documents on board of the vehicle (optional).
• CAN-bus interface for the diagnostic of vehicle (available for vehicles which stand the extended standard FMS and that request the on-board equipment of FMS interface owner of the vehicle builder)

 

Using the reading of the vehicle telemetry (available for vehicles which stand the extended standard FMS and that request the on-board equipment of FMS interface owner of the vehicle builder) the MyFleet Module allows to supervise driver’s driving and to carry out the engine’s diagnostic.

It gives current informations about:

• Spent KM
• Liters of waste fuel
• Information of fuel-tank level
• Refueling/waste of fuel
• Mean use
• Mean economy
• Vehicle time on/off
• Mean speed
• Top speed
• Driver’s driving (engine’s turns, speed, stops)

 

MyFleet Module can use 1 Mbyte of flash memory (expandable to 1Gb) and 64 Kbyte of RAM memory. The integrated GPS receiver uses the SiRF STAR IIe/LP technology with 12 channels of reception, whereas the GSM/GPRS modem it’s a tri-band Siemens (900,1800,1900MHz) multi-slot class 10, with a top speed in upload of 42.8 kbps and it supports CSD (Circuit Switched Data) communication protocols on GSM network, SMS (Short Message Service) on network GSM, end TCP/IP or UDP/IP on GPRS network.

 

MyFleet Module has also a rechargeable lithium battery for application with no out supply, a moving sensor, a sensor for the device’s inside temperature, 4 digital input, 2 analogue input at 12 bit, 3 digital output, 1 relay output, 1 data interface bus, and a serial port RS232 (o RS485).